Mounting Instructions

Note:
There is a separate clear acrylic support bar with pre-drilled holes packaged with dispensers over 14″ wide.

This support bar should be used to provide extra support for the dispenser if mounted to a wall.

The support bar is used as a support that the dispensers will rest on to help support the weight of the dispenser.

BE SURE to use heavy-duty toggle bolts or attach the screws into a wall stud. Screws, bolts, anchors, and other hardware are not included. You will need to pick the appropriate hardware for your application.

Step 1:
Determine the location for the dispenser on the wall.

Step 2:
Attach the clear support bar to the wall so the 2 square ‘blocks’ on the back near the bottom will rest on it.

Step 3:
Hold the dispenser to the wall as it rests on the support bar and measure where the remaining toggle bolts or wood screws should be placed for the upper mounting bracket.

Step 4:
The screw heads from step three should fit into the notches of the mounting bracket as the blocks rest down onto the support bar.

DO NOT OVER TIGHTEN—IT MAY CRACK THE ACRYLIC

Test to be sure you have a secure fit prior to use.